WolfVision EYE-10 User Manual - Handbuch (Seite 7)

PRESET FUNCTION
The EYE-10 offers the possibility to store the current settings as a Preset and recall them by just pressing
one of the three PRESET keys (#22) on the remote control. For storing a Preset, just adjust every function
as required and then keep one of the PRESET keys pressed for more than 2 seconds. An on-screen
message informs you, when the PRESET is stored.
When Presets are stored as mentioned above, all current settings like zoom, focus, iris etc. are stored.
4-IMAGE MEMORY
You can store 4 images and recall them by just pressing one of the numerical keys (#20):
Storing an image: Press one of the MEMORY keys (#20) for more than 2 seconds
Recalling an image: Press one of the MEMORY keys (#20) quickly.
For standard use of the 10 it is not necessary to go into the camera’s menu and change settings.
Inexperienced users should not make any adjustments in the on-screen menu.
EYE-
To enter the on-screen menu press the MENU key (#19) for 1 second. Settings of the camera's basic
functions can be made here.
To navigate, use the 4 SELECT keys (=the numerical keys with red arrows - #20).
ON-SCREEN MENU
Color / Contrast Setting
Store Power-On-Preset
For storing the Power-On-Preset just adjust every function as required and then press this item.
Every time the camera is switched on the Power
Display Logo
Mains-On
Detail
AF Region
IR Code
Erase Memory
By default, the camera will keep the image memory until it is erased manually
If you output the Visualizer image on a CRT monitor or CRT projector, use 75Hz mode, because 60Hz may
show a slight image flickering. For LCD/DLP projectors or monitors and video conferencing units 60Hz is
the best choice. If you are unsure which is the best mode, read the user manual of the connected units.
Default is 1. For stronger contrast set to 0. For softer color reproduction set to 2.
Positive / Negative Mode
The output image of the Visualizers can be switched from positive to negative in the on-screen menu.
Color / B/W (Black/White) Mode
The output image of the Visualizers can be switched from color to black/white mode in the on-screen menu.
-On-Preset will be performed.
Default is ON. If changed to OFF, the “WolfVision EYE-10”-logo is not displayed during power-up.
By default, the camera switches on when the power source is connected. If Mains-On is set to Standby, the
camera enters the standby mode when it is connected to the power source.
Also called "CONTRAST ENHANCEMENT" or "APERTURE". Default is HIGH. MEDIUM makes the image
appearing softer. OFF disables the detail function and outputs the data as seen from the CCD.
Auto-Focus region can be switched between center (AF measures in the center area of the image) and
large (measures the complete image).
Default is code A. If the IR code is changed in the on-screen menu, the IR code on the remote control has
also to be changed (see page 4).
.
Choosing Output Resolution and Frequency
6