WolfVision EYE-10 User Manual - Handbuch (Seite 2)

USE THIS MACHINE ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE LABEL !
DO NOT EXPOSE THE UNIT TO HEAT OR MOISTURE !
PROTECT THE UNIT FROM EXCESSIVE SHOCKS !
Make sure that sufficient air circulation for cooling the unit is possible!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit from mains
immediately and contact your WolfVision dealer!
Do not use a damaged power cord. This may cause short circuits or electrical shocks!
To prevent danger, do not modify the camera or operate without the cover panel firmly in place!
Do not expose the camera to water, metallic objects or any flammable material.
Avoid installing the camera in locations exposed to strong magnetic fields or electrical currents.
Avoid installing the camera in environments where there is radiation. This could cause monitor
image distortion or damage to the CCD camera.
Do not pull the plug from the power socket with wet hands!
If the camera is not used for a long time, disconnect it from mains!
The external power supply has to be approved by CSA or UL in accordance to CSA 22.2-60950 or
UL 1950.
Precautions
ENGLISH
Please observe the following:
Risk of electric shock
Dangerous voltage inside
WARNING!
Precautions for laser pointer
Laser light - Do not stare into beam!
Information for laser pointer
FDA accession number: 9912688-00
This device complies with 21 CFR 1040.10 and 1040.11
The laser beam exits the
remote control through
the smaller (left) opening
on the front.
Technical data:
λ = 635 - 680nm
P < 1mW
Θ 2mrad
This label will be found
on the underneath of
the remote control.
1