WolfVision VZ-9plu - Handbuch (Seite 16)

1. Remove the power cord of the Visualizer
2. Remove the lamp cover by turning and pulling the case
CAUTION HOT - ALLOW THE UNIT TO COOL DOWN!
(>60°C / 140°F)!
3. Lift the security ring
4. Change the lamp
Place the new lamp very carefully into the socket
5. Mount the lamp cover in reverse order (pt. 3-1).
Lamp type: Halogen lamp 12V/35W at 5000 h average burning life.
inclusive heat shield and security ring.
WolfVision part no.: 101038
If you want to work with more than one Visualizer in the same room, the units should be set
to different infrared codes, in order to control them all individually.
To change the IR code, enter the "Misc. Settings" and set the "IR
Code" to A, B, C or D (code A is default). To change the IR code on the remote control,
simultaneously press PRESET 1, PRESET 2
and ZOOM TELE
ress PRESET 1, PRESET 2
and ZOOM WIDE
on-screen menu, go to
(#34) (#32). Each time this
key combination is used, the code switches from A to B, C, D ... A ...in order given.
For resetting the remote control to code A, simultaneously p
.
The LED shows the selected code (it flashes one time for code A, two times for code B,
three times for code C and four times for code D).
Please note that an infrared remote control can only be used up to a certain
distance from the unit. Objects situated between the Visualizer and the
infrared remote control, and weak batteries, interfere with reception.
If the Visualizer can only be controlled from a close distance, or if it cannot be
controlled at all with the infrared remote control, you may have to change the
batteries.
Open the cover on the back of the remote control and replace
the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
15
MAINTENANCE
Changing the Lamp of the Visualizer
Infrared Remote Control
Different IR Codes
Cabinet: Clean the cabinet by gently wiping it with a soft, lint free cloth.
Lenses: Clean the lenses by gently wiping with a soft, lint free cloth (do not use a paper
tissue!). Clean by breathing on the lens to create moisture then wipe with a lint
free cloth (If need be, use a special optical cleaner only!).
Never use strong cleaning agents such as acetone or benzene!
These substances can damage the surface and the anti-reflex coating!
Cleaning
back (open)
-
+
-
+
X X