WolfVision PSM-10 User Manual - Handbuch (Seite 4)

#14 ZOOM-keys
For zooming in and out. Using the zoom keys also
activated the auto iris.
- see page 3 Auto Iris / Manual Iris.
#15 FOCUS-keys
When using the manual
FOCUS-keys, the PSM-10
switches off the auto focus function.
Using the AF-key switches the auto focus on again.
#16 IRIS-keys
When using the manual
IRIS-keys, the PSM-10 switches
off the auto iris function. The next time the ZOOM-keys are used
the auto iris is switched on again.
#17 WHITE-key
When the
WHITE-key is pressed, the camera preforms an
one-push white balance - see page 4.
#18 AUTO FOCUS-key
Switches the auto focus on and off.
The AF light indicates, if the AF is switched on.
#19 MENU-key
Pressing this key for 1 second activates the on-screen menu
(see page 5).
#20 SELECT-keys
For navigating through the on-screen menu
(see page 5).
#21 LASER POINTER-key
Important: Do not stare directly into the beam,
this would be bad for your eyes!
#22 PRESET-keys (programmable settings)
For storing a preset, press one of the
PRESET-keys for more
than 2 seconds. For recalling a preset, press the PRESET-key
quickly. - see page 3
#23 FREEZE-key
To capture the current image. -
see page 4
#24 POWER-key
FOCUS ZOOM IRIS
WHITE AF
MENU
14 15 16
17 18
19
20
KEYS ON THE PSM-10
2
FOCUS IRIS
FREEZE WHITE
MEMORY
1
1
2 3
4
2
MENU
AF
L
A
S
E
R
WIDE TELE
3
PRESETS
16
17 18
19
20
14
15
22
21
23
INFRARED REMOTE CONTROL
Please note that an infrared remote control can only be used up
to a certain distance from the unit. Objects situated between the
PSM-10 and the infrared remote control, and weak batteries,
interfere with the reception. If the camera can only be controlled
from a close distance, or if it cannot be controlled at all with the
infrared remote control, you may have to change the batteries.
Open the cover on the back of the remote control by hand and
replace the two 1.5 V AA batteries with new ones.
Check the polarity of the batteries!
If you want to work with more than one PSM-10 in the same room,
the units should be set to different infrared codes, in order to
control them all individually.
To change the IR-code, enter the "Misc. Settings" and set the "IR Code" to A, B,
C or D (code A is default). To change the IR-code on the remote control, simultaneously press PRESET
1, PRESET 2 and ZOOM TELE
ress
PRESET 1, PRESET 2 and ZOOM WIDE
on-screen menu, go to
(#22) (#14) - each time this key combination is used, the code
switches from A to B, C, D ... A ...etc. For resetting the remote control to code A simultaneously p
.
POWER
front back (open)
-
+
-
+
X X
FOCUS IRIS
FREEZE WHITE
MEMORY
1
1
2 3
4
2
MENU
AF
L
A
S
E
R
WIDE TELE
3
PRESETS
POWER
24