WolfVision PSM-10 User Manual - Handbuch (Seite 7)

5
For standard use of the PSM 10 it is not necessary to go into the camera’s menu and change settings.
Inexperienced users should not make any adjustments in the on-screen menu. -
To enter the on-screen menu press the MENU-key (#19) for 1 second. Settings of the camera's basic
functions can be made here.
To navigate, use the 4
SELECT-keys (=the numerical keys with red arrows - #20).
Please note that the functions of the on-screen, as shown below, may change after a firmware update.
(layout shows firmware v1.03a)
ON-SCREEN MENU
RESET OF ON-SCREEN MENU SETTINGS
All settings in the on-screen menu can be set back to the factory defaults. "Reset" is one item in the on-
screen menu.
PSM-10 Menu
Color Settings
White Balance AUTO-TRACKING
ONE-PUSH
Trigger by pressing the White-key
MANUAL
R Gain +0 (-120 to +120)
G Gain +0 (-120 to +120)
Color / Contrast Setting 1 (0, 2)
Return
Misc Settings
Detail HIGH (OFF, MEDIUM)
Focus Priority AUTO (MANUAL)
Iris Priority AUTO (MANUAL)
Digital Zoom ON (OFF)
Dig. Zoom Warning STOP (MESSAGE, NONE)
AF Region CENTER (LARGE)
IR Code A (B, C, D)
Return
Power-On Settings
Store Power-On-Preset
Display Logo
ON (OFF)
Mains-On POWER-ON (STANDBY)
Return
Pos/Neg. Mode POSITIV (NEGATIVE)
Color / B/W COLOR (BLACK/WHITE)
Output Frequency 60Hz (75Hz)
Reset Complete Menu Are you sure YES
NO
EXIT
ON-SCREEN MENU - LAYOUT
Please note: If a setting is marked with “!”, the setting is changed with the RS-232 control software.
This is only a temporary change, until the camera is disconnected from power. To change a setting
permanently, change the setting in the on-screen menu.