Monoprice 6659 4-channel H.264 Digital Video Recorder - Handbuch (Seite 17)

ADVANCED OPERATION
14
8) ALARM (Selected models only)
Select N.C. (Normally Closed) / N.O. (Normally open) / OFF for the alarm polarity. The default alarm value is OFF.
5.5. REMOTE (Selected models only)
In this menu list, you can set up remote devices to work properly.
Move to “REMOTE”, and press ”ENTER”. You will see the following submenu items:
1) TITLE
Show the camera title of each channel set in “CAMERA”.
2) DEVICE
Select the device type (CAMERA / PTZ) according to the connected camera for each channel.
3) ID
Set the ID number (0 ~ 255) for a PTZ camera. After connecting to a PTZ camera correctly, the default ID of the
PTZ camera will be shown on the screen.
4) PROTOCOL
Select NORMAL (our protocol), P-D (PELCO-D) or P-P (PELCO-P) protocol.
5) RATE
Set the baud rate of each channel (2400 / 4800 / 9600 / 19200 / 57600 / 115200). For the connected cameras,
such as PTZ and speed dome cameras, etc., please make sure their baud rate setting is the same as the setting
here.
5.6. SYSTEM INFO
In this menu list, you can check or change some system settings.
The submenu items are described below:
1) SERIAL TYPE (Selected models only)
Show the serial type of the DVR (RS485).
2) BAUDRATE (Selected models only)
Set the baud rate of the DVR (2400 / 9600 / 19200 / 38400 / 57600 / 115200).
3) HOST ID (Selected models only)
Set the ID of the DVR (0 ~ 254).
4) PASSWORD
Press “ENTER” to reset the password for accessing the DVR system. You can set the password up to 4 digits.
5) RESET DEFAULT
Press “ENTER” to reset all settings as default, and select “YES” to confirm or “NO” to cancel.
6) CLEAR HDD
Select the HDD you want to clear. Press “ENTER”, and select “YES” to confirm to clear HDD or “NO” to cancel.
7) UPGRADE
Before using the USB flash drive, please use your PC to format the USB flash drive as FAT32 format first. Then,
save the upgrade file in a compatible USB flash drive, and insert it into the USB port at the front panel. Press
“ENTER”, and select “YES” to confirm upgrade or “NO” to cancel.
Note: To use this function, you need to have the upgrade file saved in a compatible USB flash drive, and
insert it into the USB port at the front.