Spektrum SPM2800US DX10t - Handbuch (Seite 9)

9 SPEKTRUM DX10t • RADIO INSTRUCTION MANUAL
EN
6-4 Wing Type
Use the Wing Type function to select the wing and tail
that match your airplane.
Wing Types:
2 x Aileron, 2 x Flaps
• Elevon
• Elevon B
• 1x Aileron, 2 Flaps
• 1 x Aileron, 1 Flap
• 2 x Aileron, 1 Flap
• 2 x Aileron, 2 x Flaps
• Flaperon
• 2 x Aileron
• 1 x Aileron
• Tail Types
• Normal
• V Tail (A)
• V Tail (B)
• 2 x Elevator
• 2 x Rudder
• 2x Rudder, 2 x Elevator
The selected wing and tail Types are in correlation with
the Function List.
6-3 Model Name
The Model Name function allows you to name a model.
That makes identifying and selecting much easier as this
name is shown on the display.
6-5 Flight Mode
The F-Mode Setup is used to assign the switches that
will be used for Flight Mode. The actual F-Mode is on the
display.
6-8 Trim Setup
The Trim Step function allows servo movement
adjustment per click of trim.
For maximum trim, use 8–10 clicks, 5 clicks for middle
trim, the minimum trim is 1 click. If 0 is selected, the trim
function is inhibited.
For all Model Types- Normal and crossed trims swap
positions of the rudder and aileron trims.
6-6 Name Flight Mode
With the F-Mode Name, you can assign and edit Names
for the Flight Modes. There are four F-Mode Names
you can edit: Launch, Cruise, Land and Autorotation
(Helicopter only).
6-7 Channel Assign
The Channel Assign function is used to assign or change
channels. You can assign any channel to any other
channel.
In the Window below you see the Note on X-Plus
The X-Plus™ Module offers all Spektrum X-Plus receivers
the addition of 8 proportional channels. The X-Plus
activation will be done in this menu.