Enerpac PE-Series - Handbuch (Seite 5)

3. Install hydraulic hoses to valve (on pump) and cylinders.
Firmly tighten all couplers.
CAUTION: Hand tighten couplers. Do not use tools.
Excessive force will cause damage which may lead to
premature coupler failure.
4. A separate gauge
port is located on the
valve manifold. To
install a gauge,
remove the plug;
thread gauge and
appropriate fitting
into the port.
C A U T I O N :
Teflon tape is an
excellent thread
sealer. Use only 1 1 ⁄
2
wraps
on thread. Caution must
be used to prevent tape
from tearing off and
entering the hydraulic
system. Tape does not
dissolve and will cause
blockage which damages the pump.
6.0 PUMP AND VALVE ACTUATION
1. Manual Valves (PEM/WEM Models)
a. Select switch position
1. ON
2. OFF
3. JOG
b. Control hydraulic fluid flow by moving valve handle to:
1. ADVANCE
2. RETRACT
3. NEUTRAL
2. Manual Valve - JOG (PEJ/WEJ models)
a. Select switch position
1. ON (power to pendant only)
2. OFF
3. ON (Motor runs continuously)
b. Control hydraulic fluid
flow by moving valve
handle to:
1. ADVANCE
2. RETRACT
3. NEUTRAL
c. Pendant Control
1. Switch on shroud must be in
power to pendant position
(top pushed in).
2. Press pendant switch to run
motor. Release to stop motor.
3. Solenoid Valve (PER/WER Models)
a. Switch on shroud
1. ON: Motor runs, power to pendant.
2. OFF
3. ON: Motor runs, no power to pendant.
b. Valve operation is controlled by the pendant switch.
1. Press to retract
2. Press to advance
5
Gauge Port
1 2
3
B A
1 2
3
B A
ADV
RET
1
2
3
2.
1
2
3
1.
2.
1
2
3
Switch
Positions