JUMO 707020 dTRANS T02j - Four-Wire Transmitter Operating Manual - Handbuch (Seite 17)

5
2 Installation
Voltage input up to 100mV
Current input
The voltage drop on the shunt
1
must not
exceed 100 mV.
Analog outputs
Voltage output
Current output
Setup interface
1
When using a shunt resistor, the signal leads and the shunt must be provided
with a crimp connector. Without a crimp connector, there is a danger of con-
necting screws being twisted off during connection.
A
Current and voltage outputs are not
electrically isolated from each other.
The negative poles of the voltage and
current outputs must not be joined
together.
A
The setup interface and the analog out-
put are not electrically isolated.
v See “Setup interface” on page 7.