Weidmuller UPIR - Analog to frequency converter - Handbuch (Seite 17)

1
Reviewingthesetup
For review mode, press the
Å and ì keys simultaneously.
Press the Å and ì keys to move through the setup sequence (see
table). Greyed items in the setup table are not shown in review mode.
A 10 s timeout applies for review mode.
Note: You can use review mode while the instrument is in service and
the analogue and alarm outputs will still operate correctly.
Clearingtrippedalarms
You can acknowledge a tripped alarm by simply pressing the ï key.
Displayingthealarmsetpoint
To check a setpoint, simply press the ï key. If the alarm is disabled the
display will show ---- .
Adjustingthealarmsetpoint
To change a setpoint, hold down the ï key. You will then be able to
change the value using the arrows. Release the ï key to save the
value.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.
•Installation
General
These units must only be installed by qualified staff in accordance with
the information given in this manual and all relevant national electrical
wiring and safety rules must be followed.
Locate the instrument in an area that is free from dust, moisture and
corrosive gases.