Citizen Systems iDP-460 - Handbuch (Seite 44)

iDP-460 User’s Manual
44 CITIZEN
10.2 Command Sets
A command set is set by a specific command. The available commands and functions differ
depending on each setting.
(1) P-250 command set
There are two kinds of modes; P-200 mode and P-250 mode. The P-900R mode are available
with a P-900R mode and P-250 mode command. The SI, SO, RS, US, and DC2 command
operate differently between the P-200 mode and P-250 mode.
In the P-200 mode, if the 40th character in the line is received, the contents of the buffer will
be printed automatically. In the P-250 mode, the default delimits at the 42nd character and
printing is performed only after the LF command is received.
(2) P-900R command mode
Basically, this mode is the same as the P-250 mode. It can be set by a command. With the
serial interface, if a paper end error is detected in this mode, "#" will be output as the TD
signal every second until the paper end error is reset.