Citizen Systems iDP-460 - Handbuch (Seite 50)

iDP-460 User’s Manual
50 CITIZEN
[Function] 1. Serial interface 7-bit setting
High pages are specified in all the modes. If this command is received, the
character codes 20H to 7FH will be converted into A0H to FFH. This
command remains valid until the SI command or CAN command is
received.
2. Serial interface 8-bit setting and parallel interface
This command is ignored in the P-250 mode and P-900R mode. In the
other modes, it sets the double width characters(same as the RS command
<IE>H). It prints its subsequent characters as double width characters.
When there is only one character worth of position in a line, it will be
printed in normal width. This attribute remains valid until the SI
command(normal width mode) or CAN command is received.
In the P-200 mode, this attribute is reset to normal width at the beginning
of each line, every time the line is fed.
[See Also] RS, US, SI
SI ALL
[Name] Set Normal Width Mode or Reset Character Code
[Code] <0F>H
[Function] This command resets the double width character attribute or high page
setting and prints in normal width or normal character code. The print data
received after this command is printed in normal width or normal character
code.
[Caution] If double width character has been set by the SO command, the same function
as the US command will be assumed.
[See Also] RS, US, SO