Reverse, Sub trim – Losi Spektrum DX3S Radio Benutzerhandbuch

Seite 14

Advertising
background image

14

SPEKTRUM DX3S USER GUIDE

reverse

The Reverse function (also known as servo reversing)

establishes the servo’s direction relative to the channel’s

input (e.g. a right steering input should result in a right

steering angle at the car). Reverse is available on all

three channels and is normally the first function that is

checked and adjusted during programming.

To aCCess The reverse funCTIon

In the List screen use the Rolling Selector to highlight the

Reverse function.

Press the Rolling Selector to access the Reverse function.

The above screen will appear.

Use the Rolling Selector to place the box around the

desired channel that you wish to reverse.

ST=Steering

TH=Throttle

AX=Auxiliary

Press the Rolling Selector and the surrounding box will

flash. Use the Rolling Selector to select the desired servo

direction (REV or NOR).

To return to the Main screen press and hold the Rolling

Selector for more than three seconds.

sub TrIM

The Sub Trim function is normally used to correct minor

angular inaccuracies that occur when placing the servo

horn on the servo. In many cases, the servo horn is

not exactly perpendicular to the servo (or in the exact

optimum desired position). Minor sub trim values can

be used to correct this offset inaccuracy, however, it’s

important to understand that large sub trim values can

limit the total throw of the servo in that direction, so

small sub trim values only are recommended.

To aCCess The sub TrIM funCTIon

In the List screen use the Rolling Selector to highlight the

Sub Trim function.

Press the Rolling Selector to access the Sub Trim

function. The Sub Trim screen shown above will appear.

Use the Rolling Selector to select the desired channel

you wish to reverse.

ST=Steering

TH=Throttle

AX=Auxiliary

Press the Rolling Selector to highlight that channel and

the surrounding box will flash; then rotate the Rolling

Selector to adjust the value and direction of the sub trim.

To return to the main screen press and hold the Rolling

Selector for more than three seconds.

Advertising
Dieses Handbuch ist für die folgenden Produkte bezogen werden: