General notes – Losi Spektrum DX3S Radio Benutzerhandbuch

Seite 25

Advertising
background image

25

SPEKTRUM DX3S USER GUIDE

Temperature Sensor Installation (Nitro)

• Install the loop as shown around the cylinder of the

engine. It is best to place the sensor near the point

at which the head meets the cylinder to get the most

accurate consistent readings.

• Plug the temperature sensor into the port marked

TEMP in the SR3300T receiver. The Telemetry

screen on the DX3S should now display the room

temperature.

TeMperaTure sensor (eleCTrIC)

A Thermister-type temperature sensor is included in

the electric system that can be taped to the battery or

motor to monitor real time temperature. Transparent tape

can be used to attach the sensor for temperatures up

to approximately 250°F high. High-temperature tape is

needed for temperatures exceeding 250°F.

Temperature Sensor Installation (Electric)

• Tape the temperature sensor to the desired area you

wish to monitor (normally the batteries or motor).

• Plug the temperature sensor into the port marked

TEMP in the SR3300T receiver. The Telemetry screen

on the DX3S transmitter should now display room

temperature.

general noTes

Radio controlled models are a great source of pleasure.

Unfortunately, they can also pose a potential hazard if not

operated and maintained properly.

It is imperative to install your radio control system

correctly. Additionally, your level of operating

competency must be high enough to ensure you are able

to control your model under all conditions. If you are a

newcomer to radio controlled models, please seek help

from an experienced modeler or your local hobby shop.

Safety Points to Obey for Modelers

• Ensure your batteries (both transmitter and receiver)

have been properly charged for your model.

• Keep track of the time the system is turned on

so you will know how long you can safely operate

your DX3S.

• Check all servos and their connections prior to

each run.

• Do not operate your model near spectators, parking

areas or any other area that could result in injury to

people or damage of property.

• Do not operate your model during adverse weather

conditions. Poor visibility can cause disorientation

and loss of control of your model.

• Do not point the transmitter antenna directly toward

the model. The radiation pattern from the tip of the

antenna is inherently low.

• Do not take chances. If at any time during the

operation of your model you observe any erratic

or abnormal operation, immediately stop operation

of your model until the cause of the problem has

been ascertained and corrected. Safety can never be

taken lightly.

Advertising
Dieses Handbuch ist für die folgenden Produkte bezogen werden: