Chariot Carriers Chariot Baby Seat - Handbuch (Seite 46)

2.2.2 Securing on the Cabriolet, CX2 and Cougar2 models
6
Experience has shown that it helps if an overall belt length
adjustment of more or less 15 to 16 cm is made (measured from
the point of attachment to the baby seat to the point of attachment
to the trailer seat).
Now lay both straps that are at the front end of the baby seat
around the fitted telescopic tube, thread the ends through the
fasteners, as in the top right hand picture, and pull the straps
through, so that the front edge of the seat is at a distance of about
10 cm from the telescopic tube.
The next step is to connect the safety belts in the trailer with the baby seat:
Insert the trailer seat crotch
harness from the rear through
the slot in the baby seat in front
of the flap for the padding. Then insert the fastnex insert
through the elastic loop at the
end of the flap for the padding.
For side fitting, the crotch harness of the seat part of the relevant
side can be used. For centre-fitting, there is an additional crotch
harness in the centre of the trailer seat.
Please note:
The first production model
of the Cabriolet incorporated
the belt system described on
pages 6 (bottom) and 7 (top).
If your Cabriolet has this belt
system, read the section about
connecting the safety belts with
the baby seat on
page 6 (bottom) and page 7
(top), and then come back to
the text which follows in this
section.
Illustration A
First connect the fastex buckles
on the underside of the baby
seat with their counterparts on
the lap belt ends.
For side-fitting, use the belt
ends of the lap belt of the side
in question.
For fitting in the centre, use the
central belt ends of both lap
belts.
Correct positioning of the baby
seat.