Chariot Carriers Chariot Baby Seat - Handbuch (Seite 49)


The easiest way of getting the
strap tight is by pulling the end
of the strap downwards below
the seat.
View from inside with seat
lifted for clarity. Then thread the baby seat strap
that faces the middle at the front
of the baby seat down
in front of the telescopic tube,
around the bungee cord and
again back up in front of the
telescopic tube.
Then lay the strap that is on the
side of the baby seat facing out
of the trailer around the vertical
frame tube at the side and pull it
forward again over the horizontal
diagonal tube.
Thread the end of the strap as
shown in illustration A through
the fastener in the baby seat and
gently pull the strap tight.
Next, the straps at the rear end of the baby seat are attached.
In the centre of the trailer seat
backrest, there are straps for
each side for further securing
of the baby seat.
Pull the strap pointing to the
side chosen through the baby
seat fastener and pull it tight as
in illustration A.
Finally connect the fastex
buckles on the underside of the
baby seat with the buckles on
the lap belt of the side chosen.
Pull the lap belt ends equally
tight, so that the baby seat
does not tip to one side.
Finally pull all fastening straps tight.
On the Corsaire XL and Captain XL models it is important to
ensure that the baby seat is set high enough and under enough
tension, so that neither the baby’s bottom nor its back will come
into contact with the trailer seat as a result of jolts during travel.
Once all straps have been pulled tight, the front padding should sit
more or less vertical over the telescopic tube.
Please note: Make sure you check all belt buckles are tight!
Thread the end of the strap as
shown in the above illustration
through the fastener in the baby
seat and gently pull the strap
tight.
Illustration A