Chariot Carriers Chariot Baby Seat - Handbuch (Seite 50)

0
2.2.. Centre-positioning
Start by securing the straps at the front end of the baby seat.
Thread the end of the strap as
shown in the above illustration
through the fastener in the baby
seat and gently pull the strap
tight.
Illustration A
In the centre of the trailer seat
backrest, there are two straps
for further securing of the baby
seat.
Pull both straps as in
illustration A through the two
fasteners at the rear of the
baby seat and pull them tight.
Finally connect the fastex
buckles on the underside of the
baby seat with the buckles on
the lap belt of the side chosen.
Pull the lap belt ends equally
tight, so that the baby seat
does not tip to one side.
Thread both straps as shown
above down in front of the
telescopic tube. Lay the belts around the
bungee cord and pull them
back up also in front of the
telescopic tube.
Finally pull all fastening straps tight.
On the Corsaire XL and Captain XL models it is important to
ensure that the baby seat is set high enough and under enough
tension, so that neither the baby’s bottom nor its back will come
into contact with the trailer seat as a result of jolts during travel.
Once all straps have been pulled tight, the front padding should
sit more or less vertical over the telescopic tube.
Please note: Make sure you check all belt buckles are tight!