AMT Datasouth Fastmark M3 - Handbuch (Seite 28)

~ 28 ~
Printer defaults
Printer configuration will be restored to defaults as below after initialization.
Parameter Default setting
Speed 50.8 mm/sec (2 ips)
Density 8
Media Width
2.83” (72 mm)
Media Height 4” (101.5 mm)
Sensor Type Black Mark sensor (as paper end sensor)
Black Mark Setting As paper end sensor
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Post-Print Action Tear mode
Serial Port Settings 9600 bps, none parity, 8 data bits, 1 stop bit
Code Page 850
Country Code 001
Clear Flash Memory No
IP Address DHCP
Media Calibration:
Perform media calibration when completing the Initialization. Turn
ON the printer and open/close the media cover.