Eneo EHL-W/ECLKA - Handbuch (Seite 10)

0
1. Safety Instructions
The following instructions are for your own safety and should be observed without fail.
• Please read these safety and operating instructions before putting the system into operating.
• Keep the operating instructions in a safe place for later use.
• Only connect the device to a suitable electrical source.
• Never operate the housing beyond its technical specification.
• An all polarity, easily accessible mains cut-out switch with a minimum contact gap of 3mm must be installed near
the unit so that the unit may be disconnected for servicing. The earth wire must have a low impedance connection
conforming to DIN VDE 000.
• If moisture has penetrated the device, do not switch on under any circumstances.
In this case, have the device checked by a qualified service technician.
• The housing may only be opened by authorized persons. Repairs may only be carried out by qualified service technicians.
• The warranty becomes void if repairs are undertaken by unauthorized persons.
• Before opening the device, the mains voltage must be switched off.
• Cameras can be operated in a temperature range from -0°C to +50°C.
• The device must be protected from extreme heat, dust, moisture and vibration.
• Do not place any heavy items on the device.
• Pay attention to safety when laying the connection cable and ensure that the cable is not subjected to heavy loads or damage and that no moisture can get in.
• The installer is responsible for maintaining the IP 66 protection system.
• Stainless screws must be used when installing the unit outdoors.
• Only use original replacement parts from Videor E. Hartig GmbH.
Maintenance:
• The front panel should be cleaned regularly to ensure a clear display.
• It should be wiped with a soft damp cloth.
• Use only a mild detergent to clean the housing. Never use dilution or gasoline for this can cause permanent damage to the surface.
2. General Description
• Camera weatherprotection with integrated sunshield
• Fold-down aluminium housing body
• UV Resistant ABS plastic front and back part
• 3mm glass front window
• Accepts camera & lens combination up to 5mm
• Insulated camera mounting
•  Cable entry glands M6x .5mm
• Window heater included • 30V
(EHL-W/ECLKA, Art. No. 79653)
• -4V (EHL-W/ECLKB, Art. No. 79654)
• Protection rating IP66
• Surface RAL900
• Wall bracket with swivel head included
• Option: Blower kit, camera support kit
Power supply unit /4V (only at EHL-W/ECLKA, Art. No. 79653)
Parts supplied
• Weatherproof Housing EHL-W/ECLKA, resp. EHL-W/ECLKB
• Wall mount bracket
• Installation/operating manual