Burkert Type 3002 - Handbuch (Seite 13)

3001S / 3002S - 11
english
Settings
Preliminary remarks
The rotary actuators are adjusted at the factory prior to shipping. The
adjustment can be altered to suit the setting of the rotary actuator and the
positioning element driven. The voltage for the motor is supplied via the
microswitches, according to the direction of rotation. At the stopping point the
cam presses the respective microswitch thereby switching off the motor
voltage.
2-position actuator
Check the limit positions:
➔ Connect rotary actuator according to circuit diagram in the cover of
actuator.
➔ Apply voltage L1 to the motor via S1 and move to respective limit position.
At end of the motion S1 is pressed and interrupts the motor current.
➔ Apply voltage L1 to the motor via S2 and proceed accordingly.
Putting into operation
➔ Remove cover (unscrew 4 screws).
➔ Set the actuator to an intermediate setting.
➔ Check short movement orders in both directions and check the display to
see if the actuator rotates in the desired direction. (If not, check
connections).
➔ Start individual settings and see the correct position is reached.
If not, observe setting instructions.
➔ Close over.