LumaSense Technologies IN 210/4 - Handbuch (Seite 12)

IMPAC pyrometers IN 210 · IN 210/4 · IN 210/5
12
8 Settings via service interface
8.1
with HT 6000 (accessory)
The HT 6000 is a portable battery driven instru-
ment for the pyrometer parameter settings and
indication of temperature.
The pyrometer has to be connected to the HT 6000
via its service interface cable with the female SUB-
D connector. When the HT 6000 is switched on it
recognizes the pyrometer automatically and the
preset parameters can be displayed. With the
“PAR” button the different parameters can be
called. With the arrow buttons
 and  the values
of the parameters can be selected and confirmed
with the “ENTER” button. If no button is pressed for
30 s the HT 6000 changes to the temperature
indication without accepting the changed value.
8.2
with the software InfraWin (only via optional available USB adapter)
InfraWin is an adjustment and evaluation software that can
be used to read out the available parameters of the pyrome-
ter and change them, if required. Additionally the measure-
ment can be observed via a graphical surface.
For that purpose the pyrometer has to be connected to a PC
with the LumaSense USB adapter. The software recognizes
the pyrometer automatically and the preset parameters can
be displayed and changed via keyboard or a choice box, if
required.
The further functions are available:
 Reading and changing pyrometer parame-
ters
 Graphical display of the current tempera-
ture or the temperature progress
 Recording of measurement curves
 Subsequent analysis, graphically or in
table form, for print-out or export
 Spot size calculator to calculate the spot
sizes in any distances
Display
On/Off
Selection of
parameters
Up / Down
Confirmation
SUB-D connector