Electrolux EOC6851BAX - Handbuch (Seite 33)

Removing the shelf supports
1. Pull the front of the shelf support away
from the side wall.
2
1
2. Pull the rear end of the shelf support
away from the side wall and remove
it.
Installing the shelf supports
Install the shelf supports in the opposite
sequence.
The rounded ends of the shelf
supports must point to the front.
12.2 Pyrolysis
CAUTION!
If a hob is installed with the appli-
ance, do not use it at the same
time as the Pyrolysis function. It
can cause damage to the appli-
ance.
For steam models only: before
you start the cleaning procedure,
make sure that the water tank is
completely empty. Refer to “Emp-
tying the water tank”.
Remove all accessories from the
appliance.
The cleaning procedure cannot start:
• If you do not remove the shelf support
runners or telescopic shelf runners (if
present).
• If you do not close the appliance door
correctly.
• If you do not unplug the core tempera-
ture sensor (if present).
When the Pyrolysis starts the ap-
pliance door is locked. After the
function finishes the door is
locked for the cool down phase.
Some of the appliance functions
are not available during the cool
down phase.
WARNING!
When the Pyrolysis finishes the
appliance is very hot. Let it cool
down. There is a risk of burns
Pyrolysis :
1. Remove the worst of the residual dirt
manually.
2. Activate the appliance and choose
the Pyrolysis function in the main
menu. Press OK to confirm.
3.
Touch or to set the length
for the procedure:
– Quick - 1h for a low degree of dirt
– Normal - 1h 30 min for a usual de-
gree of dirt
– Intense - 2h 30 min for a high de-
gree of dirt
4. Press OK to confirm.
ENGLISH 33