Lenze CPC 9100 - Handbuch (Seite 51)

Electrical installation
Important notes
5

51 LDCDS-CPC9100 DE/EN 1.0
5 Electrical installation
5.1 Important notes
The installation must be carried out by qualified, skilled personnel familiar with the
applicable national standards.

Stop!
Short circuit and static discharges
The device contains components which can be destroyed in case of a short
circuit or static discharge.
It is especially dangerous if the device housing is opened during operation for
the exchange of the hot-swappable fan.
Possible consequences:
ƒ
The device or parts of it will be destroyed.
Protective measures:
ƒ Before carrying out works on the device which do not need the device to be
switched on:
– Shut down and switch off the IPC.
– Unplug the mains plug.
– Open the housing and, if available, disconnect the battery pack. ( 55).
– Carry out the work.
ƒ When opening the housing while a voltage is applied, be very careful and
carry out the work immediately. The following must be especially observed:
– Do not touch any current-carrying parts.
– Do not touch any rotating fan blades (risk of injury!).
– Make sure that no small parts fall into the device which would cause a
short circuit.
ƒ
All persons who work with printed-circuit boards must consider ESD
measures.
ƒ Do not touch contacts of connectors.
ƒ
Only touch printed-circuit boards at contact-free areas and only position
them on suitable material (e.g. on ESD packaging or conductive foamed
material).
ƒ Only transport and store printed-circuit boards in ESC packaging.