Fcc information (u.s.a.), Important notice: do not modify this unit – Yamaha CLP-134 Benutzerhandbuch

Seite 36

Achtung! Der Text in diesem Dokument wurde automatisch erkannt. Um das ursprüngliche Dokument anzeigen, können Sie den "ursprünglichen Modus" verwenden können.

Advertising
background image

FCC INFORMATION (U.S.A.)

1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT!

This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifi­

cations not expressly approved by Yamaha may void your authority, granted by the FCC, to use the product.

2. IMPORTANT:

When connecting this product to accessories and/or another product use only high quality shielded ca­

bles. Cable/s supplied with this product MUST be used. Follow ail installation instructions. Failure to follow instructions

could void your FCC authorization to use this product in the USA.

3.

NOTE:

This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for

Class “B” digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of

this product in a residential environment will not result in harmful interference with other electronic devices. This equip­

ment generates/uses radio frequencies and, if not installed and used according to the instructions found in the users
manual, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations

does not guarantee that interference will not occur in ail installations. If this product is found to be the source of interfer­

ence, which can be determined by turning the unit “OFF” and “ON”, please try to eliminate the problem by using one of

the following measures:

Relocate either this product or the device that is being affected by the interference.

Utilize power outlets that are on different branch (circuit breaker or fuse) circuits or install AC line filter/s.

In the case of radio or TV interference, relocate/reorient the antenna. If the antenna lead-in is 300 ohm ribbon lead,

change the lead-in to co-axial type cable.

If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute

this type of product. If you can not locate the appropriate retailer, please contact Yamaha Corporation of America, Elec­
tronic Service Division, 6600 Orangethorpe Ave, Buena Park, CA90620

The above statements apply ONLY to those products distributed by Yamaha Corporation of America or its subsidiaries.

This applies only to products distributed by YAMAHA CORPORATION OF AMERICA.

95

Advertising