Denon DN-S3000 - Handbuch (Seite 13)

13
ENGLISH
8 SEAMLESS LOOP/HOT START/STUTTER
r e
q, w,
y t, y
1
Setting the A point (loading the Hot Start
data)
q Push the A button to set the
A point and Hot Start data
loading starts.
• When an A point is set, the
corresponding A button and FLIP LED
light and that button is set to the Hot
Start mode.
3 -2
• If the B button is pushed during
Seamless Loop playback or after EXIT
playback, the B point moves to the point
at which the button was pushed.
• When the B point is set, the B and LOOP
LEDs light.
A
Seamless Loop/Hot Start/Stutter
2
Starts Hot Start
w When A button is pushed,
Hot Start playback starts
from the A point.
A
3 -1
Setting the B point for Seamless Loop
e When the B button is
pushed after setting the A
point or after starting Hot
start playback, the B point is
set and Seamless Loop
playback starts from the A
point.
4
Exit/Reloop
r In Seamless Loop playback,
you can force exit from or
return in the loop.
EXIT:
While the Seamless Loop playback, push
the EXIT/RELOOP button to exit from
loop. DN-S3000 continues playback after
the B point.
RELOOP:
When the EXIT/RELOOP button is pushed
after exit the loop, Seamless Loop
playback resumes from the A point.
5
Stutter
• A point can be also used for Stutter
playback.
t To enable stutter playback,
push FLIP button for A button,
then FLIP LED turns off.
Press the FLIP button to
switch between the Hot
Start/Seamless Loop and
Stutter modes.
6
Clear the A/B point
y While pressing the FLIP/(CLR) button, push
the A button to clear the corresponding A
and B points.
Or push the FLIP button for more than 1
sec to clear both A and B points at once.
• While pressing the FLIP/(CLR) button, push
the B button to clear the only B points.
A
Operation display (refer to the
section describing the display)