Guntermann & Drunck DVI-Extender-F - Handbuch (Seite 29)

Initiation
G&D DVI-Extender-F · 8
Initiation
After the extender has been properly installed, it can be immediately put into opera-
tion.
Mind the following activation sequence while initiating the extender:
1. Connect the power pack of the receiver (DVI-Extender-F-CON) to the mains. Use a
power cable (PowerCable-2 Standard) for this purpose.
2. Connect the power pack of the transmitter (DVI-Extender-F-CPU) to the mains.
Use a power cable (PowerCable-2 Standard) for this purpose.
3. Switch on the computer that is connected to the sender.
After the extender has been switched on, the LEDs on the front panel of the com-
puter module and the user module indicate the system’s operating status.
The chapter Status displays on page 14 provides further information on this topic.
NOTE: The recommended activation sequence for the initiation ensures that the
extender is able to read out the features of the connected monitor and to transmit
them to the computer (see DDC transmission with cache function on page 13).