Allied Telesis AT-PWR5 - Handbuch (Seite 15)

AT-PWR5 Installation Guide
5
Installing the AT-PWR5
If you are replacing a power supply, follow the steps in “Removing the
AT-PWR5” on page 7 before proceeding with the installation.
Perform these steps to install the AT-PWR5:
1. Remove all equipment from the shipping package and store the package in
a safe place.
Note
Do not remove the panel covering the expansion slot for the
AT-PWR5 unit unless you intend to install the unit.
2. Remove the two screws from the Blank Plate panel covering the expansion
slot in the rear of the media converter chassis. Remove the Blank Plate
and keep it in case you remove the power supply in the future. Refer to
Figure 2.
Figure 2 Prepare Media Converter Chassis
3. Install the power supply by sliding it into the slot opening and pressing it
firmly to seat its connector into the chassis connector. Install the two
screws as shown in Figure 3.
Power Supply __________
< Main
<< Back-Up
AC LINE
100-240 VAC
50-60 Hz
1.5A MAX.
50 W
AC LINE
100-240 VAC
50-60 Hz
1.5A MAX.
50 W
Remove Blank Plate Screws