Philips BlueTouch-Schmerztherapiegerät - Handbuch (Seite 42)

Possible reactions and side-effects
- It is normal for the skin to become a little red during treatment.
This skin redness is caused by increased blood circulation due to
the warmth of the BlueTouch Pain Relief Patch. This skin redness is
harmless and fades after the treatment has ended.
- In some cases tanning may be visible after treatment. This tanning is
caused by melanin concentrations in the skin and is a similar effect
to that caused by exposure to sunlight. It is harmless and fades away
within 48 to 72 hours. Postpone treatment until the tanning has
disappeared. To prevent tanning, resume treatment in a lower mode
and avoid excessive pressure on the BlueTouch Pain Relief Patch during
treatment, for example by sitting or lying on it or by leaning heavily
against it.
light and sound signals during use
Overheating signal
1 If the sensor measures a too high temperature, the BlueTouch Pain
Relief Patch switches off for safety reasons.
2 If the user wants to restart the BlueTouch Pain Relief Patch within 10
minutes after switching off, all LEDs flash slowly three times.
3 After the standard cooling-down time of 10 minutes, the BlueTouch
Pain Relief Patch switches on again.
Resetting signal
1 When the software of the BlueTouch Pain Relief Patch no longer
responds or another unexpected failure occurs, the BlueTouch Pain
Relief Patch automatically resets.
, During resetting, two rows of LEDs light up sequentially and you
hear four beeps.
, After resetting, the BlueTouch Pain Relief Patch works normally again.
Battery level signals
1 If, during use, the charging light flashes twice, pauses and then flashes
twice again for 5 minutes and the BlueTouch Pain Relief Patch switches
off automatically, the batteries do not contain enough energy to
continue the treatment. You have to charge the batteries before you
can use the patch again (see chapter ‘Charging’).
2 If the charging light flashes twice, pauses and then flashes twice again
for 5 minutes and you hear a single beep every 30 seconds when you
press the mode button, the batteries do not contain enough energy for
a treatment. You have to charge the BlueTouch Pain Relief Patch. The
beeping continues until you insert the small plug of the adapter into
the socket on the connection panel or insert the USB cable into the
USB connector (see chapter ‘Charging’).
english
42