Weidmuller CNDR - Universal galvanically isolated signal converter - Handbuch (Seite 15)

15
Reviewingthesetup
For review mode, press the
Å and ì keys simultaneously.
Press the Å and ì keys to move through the setup sequence (see
table). Greyed items in the setup table are not shown in review mode.
A 10 s timeout applies for review mode or you can press to quit.
Note: You can use review mode while the instrument is in service and
the analogue output and alarms will continue to operate correctly.
Clearingtrippedalarms
You can acknowledge a tripped alarm by simply pressing the key for
that channel ( ï for Alarm 1 or ENT for Alarm 2).
Displayingthealarmsetpoints
To check a setpoint, simply press the key for that channel ( ï for Alarm
1 or ENT for Alarm 2). If the alarms are disabled the display will show
---- .
Adjustingthealarmsetpoints
To change a setpoint, hold down the key for that channel ( ï for Alarm
1 or ENT for Alarm 2). You will then be able to change the value using
the arrows. Release the key to save the value.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.
Cleaning
The case can be wiped with a damp cloth. De­energise the unit before
cleaning.