AJA Hi5-3D - Handbuch (Seite 6)

Hi5-3D v2.0 www.aja.com 6
3D Modes Supported
The Hi5-3D supports, depending on the video format, “side-by-side”, “top-bottom”, and
“frame-packing” 3D modes. The “side-by-side” and “top-bottom” modes involve
compressing, either horizontally or vertically, each input for combining into a single
video stream at the same rate of the inputs.
The “frame-packing” mode stacks two full resolution inputs into a “tall” frame (at twice
the clock and line rates). When selected, “frame-packing” works only with the following
formats: 1080p23.98, and 1080p24. (Frame-packed mode does not support psf inputs at
this time.) When operating in frame-packing mode, the SDI output will be black; the valid
output is the HDMI connector.
Each input, in addition to 3D processing, can be flipped either horizontally, vertically, or
both. This control is provided by 4 switches that can be engaged in any combination—or
by use of the supplied AJA Mini Config software (Mac/PC).
Note: The Flip function is only active when in 3D mode and does not apply for pass-
through of 2D SDI inputs.
Format Support
The Hi5-3D works with both 2D and 3D inputs. When in the 2D mode, the input is simply
passed to the output unmodified—or flipped (via dipswitch or Mini Config software
selection). In the 3D mode, the Hi5-3D supports the required 3D modes as defined by the
CEA for HDMI 1.4a televisions.
CEA Required 3D modes:
NOTE: • “psf” inputs are converted to “p” for HDMI and SDI output.
• The SDI output can support S/S and T/B formats only.
• Future software versions may add other frame rates.
• When a 525 or 625 source is on both inputs, the Hi5-3D will only output one of the
sources, defaulting to Input 1. In the absence of Input 1, it will output Input 2. There are
no 3D modes with SD sources; output is simply passed through.
2xSDI 1.5gb 720p50/59.94/60 T/B
2xSDI 1.5gb 1080p23.98/24 T/B, FP
2xSDI 1.5gb 1080psf23.98/24 T/B, FP
2xSDI 1.5gb 1080i50/59.94 S/S