ALTANA Wave-Scan ROBOTIC - Handbuch (Seite 13)

12
English
You can now test the course step by
step. In the window beside the
respective button, you are informed
about the process.
run: as long as the test runs
OK: for a successful test
Error ##:for an appeared mistake (see
chapter error messages).
Course:
Config: opens the configuration-
window.
Open: opens the interface set in in the
interface-window.
DeleteValue: deletes the
measurements saved in the instrument.
Init: transfers the parameters set in
Config to the instrument.
Measure: carries out the measurement
MeasureEnd: stores the
measurements values
ReadValue: reads the saved
measurements from the instrument.
Close: finishes the test-sequence.
Set Path: here you can set the path to
the file robotic.xml. In this file, the
configuration-parameters are stored.
Get Version: shows the version of the
.dll file.
5 Software