Pioneer CT-W505R - Handbuch (Seite 28)

TROUBLESHOOTING
Symptom Cause Remedy
POOR SOUND QUALITY
Unstable or interrupted
sound
• The head, pinch rollers and capstans are dirty.
e The tape is not uniformly wound.
e Clean (see page 6).
e Completely fast-forward or rewind the tape.
No high frequencies e A tape recorded without Dolby NR is being played
back with the DOLBY NR switch in the B or C
position.
e The head is dirty.
e Set the DOLBY NR switch to OFF.
e Clean the head (see page 6).
High frequencies are
emphasized.
e A Dolby NR-encoded tape is being played back
with the DOLBY NR switch in the OFF position.
e Set DOLBY NR(B/C) switch to the same position
used for recording.
Sound from previous
recordings remains when
rerecording a tape.
a The head is dirty. a Clean the head (see page 6).
The sound is distorted.- • Recording level is too high.
e The recorded signal itself is distorted,
e The head is dirty.
e Turn REC LEVEL control down when recording
(see page 19),
e Replace the cassette,
e Clean the head (see page 6).
Too much noise e High noise tape is being used,
e Incomplete insertion of a connection cord, poor
contact.
e Recording level is too low.
e The head is dirty.
e The head is magnetized.
a Replace the cassette,
e Check connections (see page 7).
e Turn REC LEVEL control up when recording
(see page 19).
e Clean the head (see page 6).
e Demagnetize with a head demagnetizer
(see page 6).
OTHERS
The music search function
does not work. e Blanks between selections are less than
4 seconds long.
e Use a tape with blanks more than 4 seconds long.
Cannot use the remote
control system. e The control cord is not connected. e Connect the control cord (see page 7).
CD • DECK SYNCHRO is
disabled. e The components are not connected properly,
e The cassette erasure prevention tabs are broken.
e Connect them properly (see page 7).
e Replace the cassette with one whose tabs are intact
The CD SYNC indicator is
off during CD • DECK
SYNCHRO recording. e The tape ran out during the CD • DECK SYNCHRO
mode.
e After the deck entered recording standby mode,
more than 1 minute elapsed before the CD player
resumed playback.
a Replace the tape with a longer one.
• Change the disc and press the CD SYNC button
again.
Abnormal functioning of this unit may be caused by static electricity, or other external interference. To restore normal operation, turn the
power off and then on again, or unplug he AC power cord and then plug it in again.
28
<RRE1134>
En