TechniSat SkyCable DVB-S2/QAM QUAD - Handbuch (Seite 25)

25
EN
MONT_SkyCable_DVB-S2_QAM_QUAD_DE_EN_print.doc 09.08.2012 08:55 Seite 25
3. Sat SR:27500Kb Symbol-rate
The symbol rate is entered in kbaud using the numeric buttons.
The data is transferred when the OK button is pressed.
4. LNB Frq:10600MHz LNB local oscillator frequency (LO)
The LO frequency is entered in MHz using the numeric buttons and
depends on the satellite frequency range.
Ä Low band from 10.70–11.70 GHz
≙ LO = 9750 MHz
Ä High band from 11.70-12.75 GHz ≙ LO = 10600 MHz
The data is transferred when the OK button is pressed.
09750MHz = LO frequency for low band
10600MHz = LO frequency for high band
5. LNB Set:18V/22kHz Controlling the integrated multi-switch
Press the ► or ◄ cursor button to set the control voltage for the
integrated multi-switch and hence select the SAT IF level. The data is
transferred when the OK button is pressed after selection.
13V/ OK = Vertical low band
18V/ OK = Horizontal low-band
18V/22K = Horizontal high-band
13V/22K = Vertical high-band
The choice is only possible for receiving unit A and B because these two
units have connection to the internal multiswitch.
Receiving unit C get the IF level signal over loop through from Tuner A and
the receiving unit D get the IF level signal over loop through from tuner B.
Display shows the message
invalid .
Tuner C receive IF level signal from
tuner A Tuner D receive IF level signal from
tuner B
6. USB Config:No Fast configuration of input and output parameters using USB interface.
Details see section 2.3