Crivit 12V Electric Cool Box - Handbuch (Seite 8)

8 GB/CY
Tips for the best cooling output
and energy saving
Select a location which is well ventilated and
protected from sunshine.
Only place pre-cooled products into the coolbox.
Do not open the coolbox longer than necessary.
Don‘t leave the cool box lid open longer than
necessary.
Ensure that the coolbox is not packed too full
and that the air can circulate adequately be-
tween the coolbox contents.
Exchanging the 12 V fuse
See also fig. C.
To exchange the fuse 6 , first twist off the red
plug cap 3 from the plug.
Remove the fuse 6 .
Note: If the thin metal connection in the middle
between the two metal caps is broken, then the
fuse is defective and must be replaced.
Insert the new fuse carefully.
Press the contact springs
7 together, put the
red plug cap 3 back on and tighten it again.
The plug is now ready for operation.
Possible malfunctions
Firstly check whether you have correctly followed the
instructions for using the coolbox, then also check:
- Is the connection cable correctly connected
and does the cigarette lighter of your vehicle
function properly?
- Have you set up the coolbox in such a way,
that the air can circulate freely and that ventila-
tion of the cooling unit can occur?
- Is the fuse in the plug of the 12 V connection
cable OK?
If you can not rectify the malfunction on your own,
please contact our Customer Service (see chapter
on „Service“).
Cleaning and Care
Do not use any abrasive cleaning agents to
clean the product. If you do, there is a risk of
damage to the product.
Before any cleaning, pull the plug of the con-
nection cable out of the cigarette lighter. Oth-
erwise there is a risk of electric shock.
Never clean the coolbox under running water.
If you do, this could result in damage to the
electrics.
Remove the cool box cover before cleaning.
Use a damp cloth and mild washing-up liquid
to clean the cool box lid.
Use a damp cloth and a mild soap solution for
cleaning the bottom section of the coolbox.
Use clean water to rinse off those parts cleaned
with soapy water.
Recommended accessories
- AC/DC power supply unit 230 / 12 V:
For connecting the coolbox to a 230 V power
source
- DC/DC transducer 24 / 12 V:
For connecting the coolbox to a 24 V power
source
- Battery monitor:
Prevents the vehicle battery from running down
too far.
Recommended accessories are available under:
www.ipv-service.de
Disposal
The packaging is made of environmen-
tally friendly materials, which may be
disposed of through your local recycling
facilities.