Extreme Networks 12800 Series - Handbuch (Seite 104)

Installing Modules and Connecting Cables
BlackDiamond 12800 Series Switches Hardware Installation Guide 104
Figure 64: Injector/Ejector Handles in the Latched Position
CAUTION
There are two styles of ejector/injector handles on the BlackDiamond 12800 series modules. Pay careful attention to
the instructions in the next step.
8 Using a #2 Phillips screwdriver, lock the module into place in one of the following ways ( Figure 65 ):
● If the captive screw on each handle has a yellow band around the head of the screw, turn the
screw on each injector/ejector handle clockwise and completely down. When the screw is
completely tightened, the yellow band around the captive screw is completely hidden.
CAUTION
Be careful to avoid over-torquing and stripping the screw heads.
● If the captive screw on each handle has a red line on the head (see Figure 66 ), turn each captive
screw one-quarter turn (90 degrees) clockwise. When the module is correctly locked, the red line
on the captive screw in each injector/ejector handle is in a vertical position.
CAUTION
Be sure to turn each captive screw only 90 degrees or one-quarter turn clockwise. Tightening the captive screws
beyond 90 degrees will damage the injector/ejector handles on the modules.
Figure 65: Locking the Module into Place
EX_124
EX_125