Silvercrest SKGE 2000 A1 - Handbuch (Seite 10)

SilverCrest EDS SKGE 2000 A1
8 - English
Double-sided grilling
This mode (Figure A) is suitable for searing both sides of the food without having to turn it. Proceed
as follows:
 Turn the thermostat (9) to "●".

Set the slider (4) to " " in order to release the cover.
 Open the cover.
 Grease the grill plates (3 and 6) if necessary with suitable grease, margarine or oil and close
the cover. Please note that butter is unsuitable due to the high temperatures.
 Insert the mains plug into a mains socket that is always easily accessible.
 Turn the thermostat (9) to the desired setting.
Setting I = Defrost
Setting II = Heat up
Setting III = Medium level of grill
Setting MAX = Maximum level of grill
 As soon as the contact grill is connected to the mains socket, the POWER LED (7) lights up and
the contact grill starts to heat up. When the set temperature is reached, the READY LED (8) also
lights up.
 Now open the cover and place the food to be grilled directly on the bottom grill plate (6). Then
close the cover again. The contact grill heats up again once the temperature drops below the
set level. This is indicated by the READY LED (8) going out at this time.
 Switch off the contact grill after use by turning the thermostat (9) to "●" and remove the mains
plug from the socket.
 Clean the contact grill as described in the section "Cleaning".
Single-sided grilling
This mode (Figure B) is suitable, for example, for grilling a larger quantity of food. Proceed as
follows:
 Turn the thermostat (9) to "●".

Set the slider (4) to " " in order to release the cover.
 Open the cover and press the release button (5) to open the cover by 180°.
 Fold out the feet (2) and ensure that the cover is positioned securely.
 Grease the grill plates (3 and 6) if necessary with suitable grease, margarine or oil. Please
note that butter is unsuitable due to the high temperatures.
 Insert the mains plug into a mains socket that is always easily accessible.
 Turn the thermostat (9) to the desired setting.
Setting I = Defrost