FUJITSU Primergy Blade Server Systems BX600 - Handbuch (Seite 195)

Management Commands Command Reference
Intelligent Blade Panel Module
194
Enabled
Command Mode
Global Config
7.5.5 SNMP Trap Commands
7.5.5.1 show snmptrap
This command displays SNMP trap receivers. Trap messages are sent across a network to an
SNMP Network Manager. These messages alert the manager to events occurring within the
IBP or on the network. Six trap receivers are simultaneously supported.
Syntax
show snmptrap
Default Setting
None
Command Mode
Privileged Exec
Display Message
SNMP Trap Name:
The community string of the SNMP trap packet sent to the trap manager.
This may be up to 16 alphanumeric characters. This string is case sensitive.
IP Address:
The IP address to receive SNMP traps from this device. Enter 4 numbers
between 0 and 255 separated by periods.
SNMP Version:
The trap version to be used by the receiver.
SNMP v1 – Uses SNMP v1 to send traps to the receiver
SNMP v2 – Uses SNMP v2 to send traps to the receiver
Status: A pull down menu that indicates the receiver's status (enabled or disabled) and
allows the administrator/user to perform actions on this user entry:
Enable: send traps to the receiver
Disable: do not send traps to the receiver.
Delete:
remove the table entry.