FUJITSU Primergy Blade Server Systems BX600 - Handbuch (Seite 77)

Panel Settings Menu
Web-Based Management Interface
Intelligent Blade Panel Module
76
6.2.2.1.10 Configuring SNTP
Configuring SNTP Global Configuration Page
Configurable Data
Client Mode - Specifies the mode of operation of SNTP Client. An SNTP client may
operate in one of the following modes.
• Disable - SNTP is not operational. No SNTP requests are sent from the client
nor are any received SNTP messages processed.
•
Unicast
- SNTP operates in a point to point fashion. A unicast client sends a
request to a designated server at its unicast address and expects a reply from which it
can determine the time and, optionally the round-trip delay and local clock offset
relative to the server.
•
Broadcast - SNTP operates in the same manner as multicast mode but uses a
local broadcast address instead of a multicast address. The broadcast address has a
single subnet scope while a multicast address has Internet wide scope. Default value
is Disable.
Port - Specifies the local UDP port to listen for responses/broadcasts. Allowed range is (1
to 65535). Default value is 123.
Unicast Poll Interval - Specifies the number of seconds between unicast poll requests
expressed as a power of two when configured in unicast mode. Allowed range is (6 to 10).
Default value is 6.
Broadcast Poll Interval
- Specifies the number of seconds between broadcast poll
requests expressed as a power of two when configured in broadcast mode. Broadcasts
received prior to the expiry of this interval are discarded. Allowed range is (6 to 10).
Default value is 6.
Unicast Poll Timeout - Specifies the number of seconds to wait for an SNTP response
when configured in unicast mode. Allowed range is (1 to 30). Default value is 5.
Unicast Poll Retry - Specifies the number of times to retry a request to an SNTP server
after the first time-out before attempting to use the next configured server when
configured in unicast mode. Allowed range is (0 to 10). Default value is 1.
Command Buttons
Submit - Sends the updated configuration to the IBP. Configuration changes take effect
immediately.