JUMO 14597 safetyM TB/TW08 Temperature Limiter and Temperature Monitor Operating Manual - Handbuch (Seite 95)

7 Configuration level 33 2014-06-12
k
ex-factory
Scaling end for analog output -1999 ... 100 ... 9999
Behavior of the analog output in the event of a malfunction
If an allocated measured value oInP is exceeded or gone below, or if a probe
break or short-circuit occurs, it is switched to an alternative value.
it depends on the set signal type and can be set to fix current and voltage values
using 0 and 1.
0, 1
Type of signal Setting 0 Setting 1
0: 4 ... 20 mA 3.4 mA 22 mA
1: 0 ... 20 mA 0 mA 22 mA
2: 2 ... 10 V 1.7 V 10.7 V
3: 0 ... 10 V 0 V 10.7 V
Analog output
Value range
(factory-setting bold)