Lenze 931W - Handbuch (Seite 46)

Safety instructions
General safety and application notes for Lenze controllers
1
l
46 MA 13.1002 DE−EN DE/EN 1.1
Application as directed
Drive controllers are components designed for the installation in electrical
systems or machinery. They must not be used as household appliances. They are
intended exclusively professional and commercial purposes according to
EN 61000−3−2.
When installing the controllers into machines, commissioning (i.e. starting of
operation as directed) is prohibited until it is certain that the machine complies
with the regulations of EC Directive 98/37/EC (Machinery Directive). EN 60204
must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when
there is compliance with EMC Directive (89/336/EEC).
The controllers meet the requirements of the Low-Voltage Directive
2006/95/EC.
The technical data and information on the connection conditions can be
obtained from the nameplate and the documentation. They must be followed
in any case.
Warning: Drive controllers are products with restricted availability according to
EN 61800−3. These products can cause radio interferences in residential areas.
In this case, special measures are required.
Transport, storage
Please observe the notes on transport, storage and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The controllers must be installed and cooled according to the instructions given
in the corresponding documentation.
Ensure proper handling and avoid mechanical stress. Do not bend any
component and do not change any insulation distance during transport or
handling. Do not touch any electronic component or contact.
Controllers contain electrostatically sensitive components which can easily be
damaged by inappropriate handling. Do not damage or destroy any electrical
component since doing so might endanger your health!