Gastroback 41401 Mincer - Handbuch (Seite 16)

Waste disposal
The appliance has to be deposed by the definition of the regional waste disposal of
electrical scrap.
If necessary get information of the regional waste management enterprise.
Warranty
We guarantee that all our products are free of defects at the time of purchase.
Any demonstrable manufacturing or material defects will be to the exclusion of any further
claim and within 2 years after purchasing the appliance free of charge repaired or substituted.
There is no Warranty claim of the purchaser if the damage or defect of the appliance is
caused by inappropriate treatment, over loading or installation mistakes.
The Warranty claim expires if there is any technical interference of a third party without
an written agreement.
The purchaser has to present the sales slip in assertion-of-claims and has to bear all charges
of costs and risk of the transport.
The warranty becomes invalid and GASTROBACK does not assume liability if:
1. The user did not follow the instructions or the user did not use the appliance as stated and
only for thus use (improper use, misusage).
2. The appliance was connected to a power supply with improper current.
3. The mincer got opened by an unauthorised person.
4. Other then original spare-parts got used.
5. The appliance was in commercial use. Used up parts from commercial use are no
warranty claim.
The mincer is intended for use in the household only!
The mincer blocks up permanently
while operating.
The mincer head moves or loosened while
operating.
The mince leaks out at the side of the
closing ring.
Clear a blocking
If the mincer head is blocked no mince comes out of the mincer while operating or the motor stops
moving automatically because of the overload protection.
ATTENTION: If a blocking occurs turn OFF the appliance immediately. Clear the problem
before turning on the motor again.
1. Turn the appliance OFF and then take the feedstick out of the feed funnel.
2. If the motor stopped running because the overload protection turned itself on you have to
turn the appliance OFF to undo the overload protection.
3. Turn the motor ON and OFF by turns to loosen the blocking.
ATTENTION: If the motor still does not start running turn the appliance OFF, pull the plug
and clean the appliance.
• To ensure that the mincer does not seize, never operate it under
excessive pressure. Operate in a slow and constant pace. Do not
try to rush the procedure by pushing down the meat with force.
• For mincing hard ingredients really fine start with the mincer plate
with the bigger holes. Mincing the second time use the finer mincer
plate.
The screw plug loosened. Turn the appliance OFF immediately. Press the
mincer head with one hand against the motorblock using the other
hand to tighten the screw plug turning it clockwise.
The closing ring is not screwed on tight enough. Turn the appliance OFF
immediately and then pull the plug. Tighten the closing ring but do not
overwind the winding. If the problem still occurs disassemble and clean
the appliance.
Possible problem Easy solution
31 30
41401_Manual_Neu.qxp 01.10.2008 15:40 Seite 30