Electrolux EOB 53003 - Handbuch (Seite 49)

electrolux 49
Fig. 12
To perform this operation correctly,
proceed as follows:
a) the decorated internal pane with a frame
on the 4 sides must be reassembled so
that the screen-printing is facing outwards.
The side of the pane of glass is correct if
you do not feel any roughness near the
screen printing when you pass your fingers
over the surface.
The internal pane of glass must be put back
into the right seats as shown in Fig. 12.
After the panes of glass have been
reassembled in the oven door, perform the
procedure described in point 8. in reverse to
ensure they are locked.
Do not clean the oven door when it
is still hot, as the glass could shatter.
If scratches or deep cracks are
noted on the surface of the glass,
contact the authorised Assistance
Centre for replacing the glass.
Models in stainless steel or
aluminium: It is advisable to clean
the oven door and control panel in
stainless steel or aluminium only with
a moist sponge, carefully drying with a
soft cloth after cleaning. Never use
steel wool, acids or abrasive products
as they can damage the surface.
How to clean the oven door seal
A rubber seal around the oven opening
guarantees correct operation.
Check the condition of this seal
periodically. If it has to be cleaned,
do not use abrasive objects or
substances. If you notice that the
seal is damaged, contact your local
service centre and do not use the
oven until it has been repaired.
)