ROHM mandrels - Handbuch (Seite 13)

-5-
R ÖHM GmbH, Schwarzwaldstr. 5, 78112 St. Georgen/Schwarzwald, GERMANY, Tel. (49)7724-9468-0
Environmental hazards
Different lubricating, cooling and other media are required when operating a clamping
fixture. These are generally applied to the clamping device via the distributor
housing. The most frequently encountered of such media are hydraulic oil, lubricating
oil/grease and coolant. Careful attention must be paid to these substances when
handling the clamping device to prevent them penetrating the soil or contaminating
water.
Danger! Environmental hazard!
This applies:
 during assembly/disassembly, as residual quantities can still be present in
pipelines, piston chambers and/or oildrainage screws
 for porous, defective or improperly mounted seals
 to lubricants which, due to design-related reasons, emerge from or spin out of
the clamping device during operation.
 These emerging substances should therefore be collected and reused (or
disposed of in accordance with applicable regulations)!
Exchanging replacement parts:
Please note that only ORIGINAL R
ÖHM spare parts or components acquired from
suppliers authorized by R ÖHM GmbH should be used. R ÖHM GmbH bears no liability
for injury or damage resulting from the use of components from other manufacturers.
Note: Details of the 6 or 7 digit identity number engraved on the
module and the manufacturing number (if available) are
required to facilitate spare parts or individual components
ordering. The manufacturing number consists of a letter
followed by 2 numbers and, possibly, an incremental
number, this being either on the nameplate or in the near
vicinity of the identity number.
For inquiries and reordering:
Röhm GmbH
Feldbergstraße 5
D-78112 St. Georgen / Schwarzwald
GERMANY
TEL. +49(0)7724-9468-0 Manufacturer address
Röhm GmbH
Heinrich-Röhm-Str. 50
D-89567 Sontheim/Brenz
GERMANY