Weidmuller RI4 - Multi channel signal transmitter / display - Handbuch (Seite 26)

6
EXIT
Micromann Multi+
RI4 Version 2.05
Alarm Sequence
3 1 2 4
Input1= 56.9ßC
Input2= 13.6ßC
AL1 SP= 100.0ßC
MV In1= 56.9ßC
AL2 SP= 15.0ßC
MV In2= 13.6ßC
A.Out1= 1.72V
MV In3= 129.1ßC
A.Out2
Disabled
Input3= 129.1ßC
Input4= 129.6ßC
2 s
MENU
ENT
EXIT
ENT
Review Mode
Prev Next
Calibration Mode
Prev Next
AL3 SP= 120.0ßC
MV Dif= 116.0ßC
AL4 SP= 100.2ßC
MV In3= 129.1ßC
AL1 SP 100.0ßC
MV In1= 56.9ßC
Raise Setpoint
ENT Save Changes to Setpoint
MENU Accept Alarm 1
EXIT Accept Alarm 4
ENT Select mode
EXIT Return to Run mode
Lower Setpoint
Setup Mode
Prev Next
*Automatic Scrolling only
You can setup the unit to scroll automatical y
through values Input1 thru AO2 or
through the inputs on y (Input1
thru Input4).
Allowed timeouts are from 2 to 20 s.
Manual scrolling (through all the values)
sti l works as shown.
Error Messages
If one or more input wires become
disconnected, the unit will display an error
message:
Open A&B
for Bsense disconnected
Open A for A disconnected
Open B for B disconnected
Open A&B is also shown with no input
connected.
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s*
2-20 s* All Alarms Accepted
Alarm T
rigger
ed
Automatic Accept Mode
Manual Accept Mode*
Accept Alarm 2
Accept Alarm 3
*Alarm LEDs Flash until accepted
Alarms accepted automatically
and unit remains in Run mode
•Runmode
Run mode is the normal operating mode of the RI4. During run
mode the RI4 scans the inputs; calculates internal variables; updates
the display, alarm relay states and analogue outputs; and, if digital
communications are fitted, sends information to the master when
requested. It will also allow setpoint adjustment, acknowledgement
of latched alarms and review of set-up parameters via the front panel
keypad and display.
Parametersettingoverview