Weidmuller RI4 - Multi channel signal transmitter / display - Handbuch (Seite 28)

8
Adjustingthealarmsetpoints
To change a setpoint, press the ENT key when the value is on display.
Use the Å and ì keys to change the value and press the ENT key to
save.
Note: There are limits for the setpoint values that depend on the input
range setting and you cannot change the value if setpoint security is
on.
ENT
EXIT
EXIT
EXIT
EXIT
ENT
ENT EXIT
EXIT
Th s screen a lows you o select the input
for use n calculated values
Se s the number of samp es to take
when measur ng each nput (1 10)
Togg e Yes/No
EXIT Save se ection
ENT Shift selector to next nput
Toggle Yes/No
Raise Number
ENT Accept Value
Lower Number
Setup Mode
Prev Next
Measured Variable Selection
To Run Mode
Change Setup PIN
No
Alarm 1 Ave Of
1Y 2Y 3N 4Y
Input 2
Prev Next
Input 1
Prev Next
Input 4
Prev Next
Input 3
Prev Next
ENT
ENT
Input 1
Prev Next
Output Setup
Prev Next
Display Setup
Prev Next
Comms Setup
Prev Next
Alarm Setup
Prev Next
ENT
Input Setup
Prev Next
Save changes to E²PROM? Othe w se
value w ll be d scarded
Toggle
ENT Accept Value
Save Options
Save ?
Yes
Continue ?
No
Continue ?
Yes
Number of Sample
1
Set the disp ay un ts for Tempera ure
Togg e Uni s
ENT Accept Value
Togg e Un ts
Show Temperature
in Deg. C
ENT EXIT
Setup P.I.N
100
Default PIN = 100
Lower PIN
Raise PIN