Lupine Wilma 2800 Lumens - 28W - Handbuch (Seite 20)

38 39 Wilma Wilma
Engli
sh
Customizing the brightness levels
4 4
Press and hold the button (for approx. 4 seconds) until one green LED lights up.
 release the button
The range of brightness levels you can select will begin automatically to cycle, as shown below.
Press the button at the brightness level you want.
 the first power-on click is presented
You have the option to setup to 4 brightness levels , in any sequence
0.3 W brightness level
3 W brightness level
7 W brightness level
28 W brightness level
14 W
brightness level
RVLR*
1.5 W brightness level
5 W brightness level
23 W brightness level
10 W brightness level
SOS*
19 W
brightness level
Alpine SOS*
28 W
14 W
1.5 W
4.
3.
2.
1.
1.
Default setting:
3. brightness level
1. brightness level
2. brightness level
Recover factory settings:
Upon releasing the button, the sequence
of brightness levels automatically
restarts , allowing you to set a second
level in the same manner as the first click
set-up. This process can be repeated up
to four times, but will stop when you quit
making further selections, thus allowing
your light to operate in 1-step, 2-step,
3-step,-or 4-step modes.
Default setting
Press and hold the button for about 8 seconds, until 5 red LEDs turn on.
 release the button
2.
Disconnect the battery, and all factory settings will be restored.
Flash*
* Will not be signalised by status LED
This mode offers a slow flash mode.
RVLR:
This mode is extremely irritating and may by no means be misused.
Flash 15hz: (Disorientation)
SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
SOS:
Alpine SOS will continue until the battery is empty. Improper use of the SOS
signal is punishable by law.
Alpine SOS: