Lupine Wilma 2800 Lumens - 28W - Handbuch (Seite 22)

42 43 Wilma Wilma
Engli
sh
7 7
Special Functions
Press and hold the button (for approx. 6 seconds)
until 3 green LEDs light up.
release the button
Before activating the alternative capacity indicator,
your battery must be fully charged.
The range of brightness levels you can select will
automatically begin to cycle, as shown.
The range of battery capacities you can choose
from will start automatically.
Press the button when the brightness level you
want is presented.
You must approximate the correct range for your
battery; e.g., for an 13.2Ah you would select 14Ah
(5 blue LEDs)
 Similair to our Smartcore batteries the red LEDs
on the lamphead will now approximatley show the
remaining capacity.
Depressing the button for 3 seconds will initiate
the flash mode selected, and the lamp will
continue flashing in that mode until the battery
is completely discharged.
2 Ah
4 Ah
6 Ah
12 Ah
8 Ah
16 Ah
20 Ah
3 Ah
5 Ah
10 Ah
7 Ah
14 Ah
9 Ah
18 Ah
3.
3.
2.
2.
1.
1.
Additional beams for special applications:
Changing the factory-set SOS function see page 35
Alternative Capacity Indicator (lamp-head):
Attention! When the lamp-head is disconnected
from a battery, the status information is lost. You
need to fully recharge the battery to make it work
again.
0.3 W brightness level
3 W brightness level
7 W brightness level
28 W brightness level
14 W
brightness level
RVLR*
1.5 W brightness level
5 W brightness level
23 W brightness level
10 W
brightness level
SOS*
19 W brightness level
Alpine SOS*
Default setting
It is possible to change the factory-set SOS signal to
different brightness levels, or to special-purpose RVLR or
Alpine Emergency signals.
Press and hold the button (for approx. 5 seconds)
until 2 green LEDs light up.
 release the button
Disable indicator
Flash*
* Will not be signalised by status LED