Programming charger one, Charger one, Programming scheme – Lupine FastClick Batteries Benutzerhandbuch
Seite 14: En gl is h, The options at a glance, Li-ion, Form, Disc, Li 50, Ni-mh
26 Charger One/Micro Charger/Wiesel/Piko TL
27
Charger One/Micro Charger/Wiesel/Piko TL
En
gl
is
h
3
2
Programming Charger One
Charge
select: press key ... charge
Press the button quickly to switch from the default
charge
to
1-+ charge; to select 3-+ charge,
press the button again.
These two modes are particularly useful for “training” NiMH batteries in that the battery is
automatically charged and discharged three times.
Note:
If you select this option, each time you plug the battery into the charger, the following
message will be displayed:
"ABCDE 1-+ charge or 3-+ charge".
Five seconds later the following message will appear, regardless of whether you press the button:
Limit charging current
select: press key ... | max: 2.5 A
In this option, each short press of the button reduces the charging current
(starting from the 2.5 A
default value)
by 0.4 A, whereby the cycle starts over again the next time the button is pressed after
you reach 2.1 A.
This mode is useful for fully charging very old batteries.
Five seconds later the following message will appear, regardless of whether you press the button:
Limit charged capacity
select: press key ... Max Ah: 20 Ah
To increase the maximum charged capacity in 0.5 Ah increments, press the button repeatedly
(up to the 20 Ah default setting). Limiting charged capacity helps to improve the reliability of
batteries whose quality is unknown (this does not apply to Lupine batteries). Here too the program
advances at five second intervals, regardless of whether the button is pressed. The device now
reverts automatically to the main menu and can be used for charging.
Helpful hint:
If you do not wish to change any setting, simply refrain from pressing the button
while the program progress through the various menu items. This is also the easiest way to
restore submenu default settings.
The options at a glance:
Hold button down for
3 seconds
SELECT
Li-Ion
Settings
changes every
5 seconds
SELECT
SELECT
SELECT
Charge
Limit
charging current
Limit
charging amount
charge and
discharge once
charge and
discharge three times
Hold button down for
3 seconds
SELECT
Ni-MH
Settings
changes every
5 seconds
changes every
5 seconds
SELECT
SELECT
SELECT
Charge
Limit
charging amount
Hold button down for
3 seconds
SELECT
Li 50 %
Settings
No further
settings possible
Hold button down for
3 seconds
SELECT
disc
Settings
No further
settings possible
Hold button down for
3 seconds
SELECT
form
Settings
changes every
5 seconds
changes every
5 seconds
changes every
5 seconds
SELECT
SELECT
SELECT
Charge
Limit
charging amount
SELECT
Li-Ion
SELECT
form
SELECT
disc
SELECT
Li 50%
SELECT
Ni-MH
See page 22 for a description of the
restore default settings procedure.
charge and
discharge once
charge and
discharge once
charge and
discharge three times
charge and
discharge three times
Limit
charging current
Limit
charging current
Charger One
programming scheme