Sony RM-VL900T - Handbuch (Seite 39)

39 GB
To transfer the data of a
Component Select button
The data of a Component Select
button on this Commander (the
settings and “learned” signals
programmed on the buttons) can
be transferred to a Component
Select button on another Sony
RM-VL900T or RM-AV2100T.
1-2
Perform Steps 1 to 2 on
page 38.
3
While holding cursor v
pressed, press the
Component Select button
whose data you want to
send.
The S (set) indicator flashes
and the selected Component
button lights up.
4
Confirm that the receiving
remote commander is ready
to receive data.
(To set the receiving
commander, follow the
procedure on page 42.)
Note
Be sure that the sending remote
commander is ready to transfer
data.
4
Confirm that the receiving
remote commander is ready
to receive data.
(To set the receiving
commander, follow the
procedure on page 40.)
Note
Be sure that the sending remote
commander is ready to transfer
data.
5
Press ENT (Start data
transfer).
As the data is transferred, the
corresponding Component
Select buttons turn off one by
one.
If data transfer has been
unsuccessful during or after
procedure, the S (set) indicator
and all Component Select
buttons flash five times, and
the Commander returns to its
state in Step 3.
Either try again from Step 5, or
press S (set) to cancel data
transfer.
Note
Be sure that the receiving Commander
is ready to receive data.
Continued