Sony RM-VL900T - Handbuch (Seite 46)

46 GB
Troubleshooting (continued)
Symptom
The S (set) indicator or
the Component Select
buttons flash five times
All Component Select
buttons flash twice
during an operation
A System Control
program does not
function correctly.
All Component Select
buttons flash twice
Your Commander does
not work as expected
after Data Transfer
Remedy
• Learning has not succeeded. See “For accurate Learning”
(page 18) and try the Learning procedure again (page 15).
• The component codes cannot be set. See the supplied
“Component Code Numbers” and try setting the component
codes again (page 8).
• The data have not been transferred. See “Transferring the
data” (page 38) and try transferring the data again.
• The data have not been received. See “Receiving the data”
(page 40) and try receiving the data again.
• Clear infrequently used Learned functions (page 19), then
carry out learning operations.
Signals have been programmed for that Component Select or
SYSTEM CONTROL button using the Learning function. Clear
the “learned” signals (pages 19, 26, 28) and try programming
the System Control function again.
• Make sure that you have programmed the commands in the
correct order (pages 24, 27).
• Try changing the orientation of the Commander. If that does
not help, try placing the components as close to each other as
possible.
• Check the status of the components and make sure that you
have set the components properly to receive commands (page
27).
• The component code is changed or a new signal is “learned”
on a button that has been programmed in the series of
commands. In this case, the new signal is transmitted when
the series of commands are executed.
• The interval may be too short. See “Changing the interval
between operation steps” (page 29) and set a longer interval.
• The Hold function is on. Unlock the Hold function (page 43).
Data Transfer to/from a single button cannot transfer System
Control functions that are “learned” by Component Select
buttons. Either set up the “learned” Commander from the start,
or perform whole Data Transfer.
Note on the data transmission with Sony RM-AV2100T
When transferring data between this commander and another Sony RM-AV2100T
remote commander, some functions may not be able to be transferred (e.g. system
control function).